A practical reference on Ac-LKKTETQ: what it is, how it behaves, what the literature reports, and where the honest uncertainties sit.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
TB-500 is a shorthand label used in supplier catalogs and online discussion for a short synthetic peptide described as a fragment of thymosin beta-4. Most product listings present it as the N-terminally acetylated heptapeptide Ac-LKKTETQ, a sequence corresponding to the actin-binding region of the parent protein. The name is not a formal chemical designation and does not appear in standard nomenclature systems. Because labeling practices vary between vendors, two products sold under the same name may not contain the same molecule, and the stated sequence should be treated as a claim rather than a fixed definition.
Thymosin beta-4 is a naturally occurring protein of 43 amino acids found in most mammalian cells, where it binds actin monomers and influences filament dynamics. It was first isolated from thymus tissue in the early 1980s, and its actin-binding activity was later mapped to a short region near the N-terminus. The synthetic fragment sold as TB-500 was designed to reproduce that region rather than the full protein. Whether a short fragment reproduces the behavior of the intact molecule remains an open question, since the parent protein carries additional structural elements outside the binding region.
| Property | Value | Notes |
|---|---|---|
| Molecular formula | C38H68N10O14 | Calculated for the acetylated heptapeptide |
| Molecular weight | ~889 Da | Monoisotopic mass approximately 889.0 Da |
| Amino acid sequence | Ac-LKKTETQ | N-terminal acetylated seven-residue peptide |
| Appearance | White to off-white powder | Typically supplied as a lyophilized solid |
| Solubility class | Water-soluble | Peptides of this size generally dissolve in aqueous media |
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
TB-500 is a synthetic seven-amino-acid peptide with the sequence LKKTETQ, corresponding to residues 17 through 23 of the protein thymosin beta-4. The N-terminus is typically acetylated in the described form, giving a monoisotopic mass near 888.5 Da and an average mass of about 889 Da. The designation TB-500 is a catalogue label rather than a formal chemical name, and the same sequence appears in the literature under several alternative abbreviations. It is handled as a research reagent rather than a pharmaceutical product.
Thymosin beta-4 is a 43-residue actin-binding protein found in most mammalian cell types, where it participates in cytoskeletal regulation and cell migration. TB-500 represents only a short fragment of that protein and does not include the remaining residues. Whether the isolated fragment reproduces the full range of activities reported for the intact protein remains an open question. Researchers commonly treat the two as related but distinct entities when comparing results.
Dry peptide powder is commonly kept at −20 °C in a desiccated container away from light, a practice that limits moisture uptake and oxidation. Once dissolved, solutions are generally held at 2–8 °C for short periods or frozen at −20 °C or lower for longer storage, with repeated freeze-thaw cycles avoided. Hydrolysis and oxidation are the main degradation routes for peptides in solution, and both accelerate at higher temperature or extreme pH. Published stability data specific to TB-500 are limited, so shelf life should be treated as uncertain.
Identity and purity checks for peptide material typically combine reversed-phase high-performance liquid chromatography with mass measurement, since retention time alone cannot confirm a sequence. Mass measurement verifies the expected molecular mass within instrument tolerance, while chromatographic peak area provides a purity estimate. Anti-doping analysis of urine uses related but more sensitive workflows, sometimes after solid-phase extraction. For research material, batch documentation, certificate content, and independent testing are common points of scrutiny, because supply chains outside pharmaceutical regulation vary widely in the paperwork they provide.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Nevertheless, the resistance of extracellular matrix proteins to proteolysis renders their advanced glycation end products less conducive to being eliminated. While the AGE free adducts are released directly into the urine, AGE peptides are endocytosed by the epithelial cells of the proximal tubule and then degraded by the endolysosomal system to produce AGE amino acids. It is thought that these acids are then returned to the kidney's inside space, or lumen, for excretion. AGE free adducts are the major form through which AGEs are excreted in urine, with AGE-peptides occurring to a lesser extent but accumulating in the plasma of patients with chronic kidney failure. Larger, extracellularly derived AGE proteins cannot pass through the basement membrane of the renal corpuscle and must first be degraded into AGE peptides and AGE free adducts. Peripheral macrophage as well as liver sinusoidal endothelial cells and Kupffer cells have been implicated in this process, although the real-life involvement of the liver has been disputed.
About 1,500 heat-related deaths occurred in the Netherlands, again largely the elderly. The heat wave broke no records, although four tropical weather-designated days in mid-July, preceding the official wave, are not counted due to a cool day in between and the nature of the Netherlands specification/definition of a heat wave. The highest temperature recorded this heatwave was on 7 August, when in Arcen, in Limburg, a temperature of 37.8 °C (100.0 °F) was reached, 0.8 °C below the national record (since 1904). A higher temperature had only been recorded twice before. On 8 August, a temperature of 37.7 °C (99.9 °F) was recorded, and 12 August had a temperature of 37.2 °C (99.0 °F). Initially, 141 deaths were attributed to the heat wave in Spain. A further research of INE estimated a 12,963 excess of deaths during summer of 2003. Temperature records were broken in various cities, with the heat wave being more felt in typically cooler northern Spain. Record temperatures were felt in:
The formation of amino acids and peptides is assumed to have preceded and perhaps induced the emergence of life on earth. Amino acids can form from simple precursors under various conditions. Surface-based chemical metabolism of amino acids and very small compounds may have led to the build-up of amino acids, coenzymes and phosphate-based small carbon molecules. Amino acids and similar building blocks could have been elaborated into proto-peptides, with peptides being considered key players in the origin of life.
Sources: en.wikipedia.org
Acceptance sampling uses statistical sampling to determine whether to accept or reject a production lot of material. It has been a common quality control technique used in industry. It is usually done as products leave the factory, or in some cases even within the factory. Most often a producer supplies a consumer with several items and a decision to accept or reject the items is made by determining the number of defective items in a sample from the lot. The lot is accepted if the number of defects falls below where the acceptance number or otherwise the lot is rejected. In general, acceptance sampling is employed when one or several of the following hold: testing is destructive; the cost of 100% inspection is very high; and 100% inspection takes too long. A wide variety of acceptance sampling plans is available. For example, multiple sampling plans use more than two samples to reach a conclusion. A shorter examination period and smaller sample sizes are features of this type of plan. Although the samples are taken at random, the sampling procedure is still reliable.
Galega officinalis (French lilac) was used in diabetes treatment for centuries. In the 1920s, guanidine compounds were discovered in Galega extracts. Animal studies showed that these compounds lowered blood glucose levels. Some less toxic derivatives, synthalin A and synthalin B, were used for diabetes treatment, but after the discovery of insulin, their use declined. Biguanides were reintroduced into Type 2 diabetes treatment in the late 1950s. Initially phenformin was widely used, but its potential for sometimes fatal lactic acidosis resulted in its withdrawal from most pharmacopeias (in the U.S. in 1978). Metformin has a much better safety profile, and it is the principal biguanide drug used in pharmacotherapy worldwide.
The role of inflammation in cancer is not well understood. Some organs of the body show greater risk of cancer when they are chronically inflamed. While there is an association between increased levels of C-reactive protein and risk of developing cancer, there is no association between genetic polymorphisms influencing circulating levels of CRP and cancer risk. In a 2004 prospective cohort study on colon cancer risk associated with CRP levels, people with colon cancer had higher average CRP concentrations than people without colon cancer. It can be noted that the average CRP levels in both groups were well within the range of CRP levels usually found in healthy people. However, these findings may suggest that low inflammation level can be associated with a lower risk of colon cancer, concurring with previous studies that indicate anti-inflammatory drugs could lower colon cancer risk.
Sources: en.wikipedia.org
TB-500 is a synthetic heptapeptide corresponding to a fragment of thymosin beta-4. It is used in laboratory research and is not an approved drug.
No. Thymosin beta-4 is a 43-amino-acid protein, while TB-500 represents only a short N-terminal segment. The two should not be treated as interchangeable in experimental design.
It is often called a thymosin beta-4 fragment, Tβ4 fragment, or Ac-LKKTETQ. The name TB-500 is mainly a commercial or catalog label rather than a formal chemical name.
Most listings describe it as a short acetylated peptide with the sequence Ac-LKKTETQ, presented as a region of thymosin beta-4. The label is a trade-style name rather than a standardized chemical name, so the exact content of a given vial depends on the supplier.